1/21/2024 0 Comments Red overlay edit![]() ![]() Measure Bandwidth (Burst Mode): Choose this option to perform short bursts of UDP traffic to an SD-WAN Gateway for public links or to the peer for private links, to assess the bandwidth of the link.To overcome this behavior, choose this option for a sustained slow burst of UDP traffic followed by a larger burst. Measure Bandwidth (Slow Start): When measuring the default bandwidth reports incorrect results, it may be due to ISP throttling.Advanced Settings common for Public and Private Overlay OptionĬhoose a method to measure the bandwidth from the following options: If this option is not available for you, contact the VMware support of your operations team to enable the setting.Ĭlick Advanced to configure the following settings: Table 5. This checkbox is available only when the system property 8021PConfiguration must be set to True. The range is from 000 to 111 and default is 000. PCP priority values are a 3-digit binary number. This setting is only available for a specific VLAN. Sets 802.1p PCP bits on frames leaving the interface to which the current overlay is attached. This option applies the VLAN tag to the packets originated from the Source IP Address of a VCMP tunnel from the interface to which the current overlay is attached. ![]() Select the checkbox to enable custom VLAN and enter the VLAN ID. You can enter IPv4 or IPv6 address to establish WAN overlay with the peer.Įnter the next hop IP address to which the packets, which come from the raw socket source IP address specified in the Source IP Address field, are to be routed. Source IP address does not have to be pre-configured anywhere but must be routable to and from the selected interface. This is the raw socket source IP address used for VCMP tunnel packets that originate from the interface to which the current overlay is attached.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |